Vessel Printing 2

 Unfortunately the original design that I was going to fabricate didn't work and couldn't figure out what the problem is, even after approaching to expert. So I got the g-code with different model that has similar quality, which has star like base shape but with multiple layers of swirls.

This is the setting that I used. I used 5% infill since I was worried that the shape has some excessive vertical curves, and it might be hard to print without inner support. I checked that there's no overhanging part from the top left report, and checked the entire time.

< Slicing >

< Printing >

Final Presentation

It is shame that I couldn't figure out what was the problem with original design. I was guessing the wavy outside with different direction might be it but from the observation that the 3D printer printing my infill, it didn't seem to be a problem (infill printed had direction changing over time). For next chess project, I should minimize design and make sure that corners are aligned well.